When a council looks at an extension that needs planning permission, one of its first questions is what it does to the neighbours’ light. The usual test is called the 45-degree rule.
It comes from the Building Research Establishment’s guide to daylight and sunlight, and most London councils use a version of it in their design guidance. It is a rule of thumb, not a law: a quick way to spot an extension that might cause a problem.
How the test works
Take the nearest window of a habitable room in the neighbour’s house — a kitchen, living room or bedroom, not a bathroom or hall — that faces the same way as your extension.
- On plan, draw a line at 45 degrees from the middle of that window towards your extension.
- In elevation, draw a line at 45 degrees downwards from the top of your extension towards the window.
If the middle of the window falls inside both lines, the extension may take a significant amount of daylight, and the council will look closely. If it falls outside either one, the extension usually passes.
What it means in practice
This is why a single-storey rear extension on a terrace usually passes even when it is built right up to the boundary: on plan the 45-degree line may cross it, but the extension is low enough to sit under the elevation line. A two-storey extension of the same depth often fails, because its height brings it above that line.
Councils vary in the details. Some measure from a point a quarter of the way across the window rather than its middle; some apply the test only to two-storey extensions; some use 60 degrees in elevation. Your council’s design guidance will say which.
Designing within it
- Step the extension in from the boundary, so the plan line clears it.
- Slope the roof down towards the neighbour, keeping the eaves low where it matters.
- Keep the upper storey back further than the ground floor.
- Use glass where the extension meets the boundary, which takes less light than a solid wall.
HomeFinder runs an indicative version of this test on its 3D estimate and draws the 45-degree lines for you. It assumes typical window positions, so it is a first look rather than a daylight study. Where it matters, a full assessment measures the actual windows.
Check your own address. HomeFinder, our free tool, looks up the planning registers, the decisions near you and a 3D model of your house for any London address. For your borough’s approval rates, see the borough guides.
This is general information about the rules in England, not advice on your project. Permitted development has conditions this page can’t cover in full; before you build, confirm with your council (a Lawful Development Certificate gives you certainty) or with an architect.
← All journal entries